Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

One of my customers is using TI C2000 F280025C-Q1 in their design for Electronic Coolant Pump EE. Most of the SW dev is already done but they are now stuck at achieving the optimal performance of the ...

There is no API available for checking the integrity of the SBL image. If really required, the ROM bootable image is signed with X.509 certificate which contains SHA512 hashes of the different ...

I'm working on this part number "TMS320F2808PZA" and i can't found Software tools for code generation for this family i tried Sysconfig and i can't found this family in it. is there any solution you ...

Are you using an example project as the basis for your project? If not, I recommend referring to one of those examples to make sure you have the proper libraries linked and include options configured.

I am working with the 280039C launchxl board. I have a C:\ti\c2000\C2000Ware_5_02_00_00\driverlib\f28003x\examples\spi working which has a .syscfg file - ...

I'm going to use AWR1642EVM with DCA1000 to get the MIMO raw data, and generate a virtual antenna array. (as figure 5) (FIGURE BELOW IS FROM TI DOCUMENT.) I know that there are two TX and four RX on ...

I am configuring a new laptop with TI development tools, using the same products as on an older computer. The older computer has been running CCS version 12.4 and C2000ware version 5.02.00.00 for over ...

Looking at the EVM circuit, it was confirmed that 7.87K and 82.5K are divided into 3.3V voltage and input, but is it not possible to input 3.3V with a 10K pull-up? I need an accurate guide on what ...

Would you mind if we ask TLV9002? There is the description "Open-loop output impedance=1200ohm" on the datasheet. We would like to know output impedance in case of ...

I have a problem with the DAC output: it always stays at 0 volts. To provide some context, I designed and prototyped two bipolar voltage sources using the DAC8812 and two OPA2277 (based on the bipolar ...

I am doing the simulation in LTspice. With the same circuit, I see something wrong with the output of LM2903B. May I ask for some help? Either my circuit is wrong or the model itself is not correct.